Garbage Disposal Repair & Installation in Loveland, CO
Jammed, leaking, or dead garbage disposals repaired same day, or a new unit installed and connected, with a flat price before any work begins.
Signs Your Disposal Needs Attention
Humming, Not Spinning
Motor runs but the flywheel doesn't turn, almost always a jam.
Leaking Underneath
Water pooling under the sink, usually a worn seal or cracked housing.
Won't Turn On At All
No sound at all, often a tripped reset button or wiring issue.
Foul Odor Or Slow Drain
Trapped food debris or a partial clog past the disposal chamber.
Why Disposals Jam Or Leak
A jam is almost always something the flywheel can't grind, fruit pits, bone fragments, fibrous produce like celery, or utensils that fall in by accident. The fix is usually a manual reset with the hex key that ships with most units, then clearing whatever caused the jam. Leaks are a different problem entirely. They come from the rubber seal around the sink flange breaking down over years of use, or from a cracked housing after the unit has taken a hard jam one too many times. We check both the flange seal and the housing itself before recommending anything, since a seal replacement is a much smaller job than a full unit swap.
Installation itself follows the drain-sizing and trap requirements set out in the Uniform Plumbing Code (UPC) that Colorado has adopted, which is why a disposal can't just be plumbed into any existing drain line without checking trap arm length and venting first. That's a code detail homeowners rarely need to think about, but it's the difference between a disposal that drains properly for years and one that backs up within months.
One local wrinkle worth knowing: a meaningful share of Loveland's older homes near downtown still run cast iron drain lines rather than modern PVC, and cast iron narrows over decades as mineral scale and corrosion build up inside the pipe wall. A disposal that runs constantly into an already-narrowed cast iron line backs up more easily than the same unit draining into PVC. That's why a disposal problem in an older home sometimes turns out to be a drain-line problem once we get a camera in the line. It's worth mentioning on the phone if your home was built before the 1970s.
Disposal Humming And Won't Spin?
A technician can usually clear a jam and reset it same day.
When A New Unit Makes More Sense
Most jams and single leaks are worth repairing, especially on a unit under five years old. Once a disposal has failed more than once in a year, or the motor itself has burned out (a sign is a reset button that trips repeatedly with no jam present), replacement is usually the better value. We stock common residential horsepower ratings and can typically complete a swap in the same visit as the diagnosis.
Jam clearing and seal repairs on the low end, full replacement with a new unit on the high end. Exact quote after inspection.
How A Disposal Call Works
Inspect
Check the flywheel, reset button, seal, and housing.
Quote
Flat price for repair or replacement before work starts.
Fix
Jam cleared, seal replaced, or new unit installed.
Test
Run water and grind test before the technician leaves.
Disposal Questions From Loveland Homeowners
Usually yes, without a full replacement. A humming disposal almost always means the flywheel is jammed, and clearing the jam and resetting the unit fixes it in most calls.
Leaks usually come from a worn seal around the sink flange or a cracked housing. A seal replacement handles most leaks. A cracked housing means the unit needs to be replaced.
Most residential units run 8-12 years with normal use. A unit that's jammed or failed more than once in the last year, or is over a decade old, usually makes more sense to replace than keep repairing.
Yes, when a unit isn't worth repairing we carry common residential models and can complete a swap the same visit in most cases.